The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools
Old December 16, 1999, 06:43 PM   #1
Senior Member
Join Date: October 4, 1999
Posts: 317

I'd like to try my hand at removing
the trigger creep on my Colt series
70 government model.
Your advice is appreciated.
Sport is offline  
Old December 16, 1999, 09:59 PM   #2
George Stringer
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Sport, you're probably going to think I'm not a very good one. I don't give advise on trigger work. This is an area that I believe is best left to a gunsmith. George
George Stringer is offline  
Old December 16, 1999, 11:38 PM   #3
Junior member
Join Date: November 7, 1999
Posts: 1,516
Fortunately, my 70 Series G.C. has no creep. Has a great trigger. I've adjusted all the overtravel out, as well. Wish I could help with the Government model, but George is right about the creep on the 1911. Go to a competent 1911 gunsmith.

[This message has been edited by WalterGAII (edited December 17, 1999).]
WalterGAII is offline  
Old December 17, 1999, 05:45 AM   #4
Senior Member
Join Date: October 4, 1999
Posts: 317

To a gunsmith it shall go.
Sport is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:05 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.06276 seconds with 7 queries