The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old August 16, 1999, 07:29 PM   #1
swifter...
Senior Member
 
Join Date: March 16, 1999
Location: So. CA Mountains
Posts: 540
I found the forearm hanger on my TC carbine was cockeyed. The forward dovetail screw had slipped to one side. The rear was solid.
Can some one: a) Confirm my suspicion that this is a major cause of the poor groups I've been getting lately. & b) Make some suggestions as to what - epoxy, Loc-Tite, etc. - is most likely to hold it firmly?
TIA

------------------
The Bill of Rights, and the Golden Rule are enough for civilized behavior. The rest is window dressing. Shoot carefully, swifter...

swifter... is offline  
Old August 16, 1999, 09:39 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Swifter, I would "dimple" the dovetail. Use a center punch and make several dimples inside it. This will tighten it. George
George Stringer is offline  
Old August 17, 1999, 02:27 PM   #3
Cheapo
Senior Member
 
Join Date: November 19, 1998
Posts: 986
Contact Bullberry Barrel Works out west somewhere. They do have a web site, but I haven't been to it and don't have the URL.

Sorry 'bout that part.

The fore-end hanging element is a known trouble spot in the TC series. Fix that and put a good barrel on it, and you're looking at .5 MOA or better with most calibers.
Cheapo is offline  
Old August 17, 1999, 03:43 PM   #4
slabsides
Member In Memoriam
 
Join Date: May 27, 1999
Location: Maine
Posts: 614
I have three factory Contender carbine barrels: A blued .223, a stainless 7-30 Waters, and a .44 Mag Super 16. All three of them have loose forearm screw bushings. I took one of them out with my fingers, because my old-style forend only has one screw hole. The .223 will group well under moa with its 4x Burris compact scope. The Waters has the same scope and groups 1 to 1 1/2 inches with Federal factory loads. The .44 Magum has the original factory patridge sights, and shoots Winchester factory hollowpoints into 1 1/2 three-shot groups at 100 yards. My feeling is that screw bushing looseness isn't a factor in accuracy. Contact of the 'cheeks' of the forend with the action, and proper contact of the forend inletting with the barrel, now...that's another matter... slabsides

------------------
An armed man is a citizen; an unarmed man is a subject; a disarmed man is a slave.
slabsides is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06695 seconds with 9 queries