The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 27, 1999, 06:33 PM   #1
JJR
Senior Member
 
Join Date: June 4, 1999
Location: Idaho
Posts: 381
I would like to put night sights on an existing Beretta 92FFS. As you probably know, the front sight on the Beretta is part of the slide (non-removable).

Can the "dot" on the front sight be milled out and a trijicon "dot" inserted in it's place? Does anyone perform this service? Any other ideas? Any advise would be greatly appreciated.
JJR is offline  
Old July 27, 1999, 11:19 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Any of the night sight companies, Meprolight, PT Nightsites, etc. should be able to drill and fill the front sight but it may be too thin. If this is the case they will want to dovetail and fit a front. George
George Stringer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:27 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05466 seconds with 7 queries