The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 16, 1999, 10:52 AM   #1
Bill Hebert
Senior Member
 
Join Date: May 15, 1999
Posts: 180
I've bought a recoil pad and want to install it on a fiberglass stock. The butt dimension of the stock fall between the "medium" and "large" recoil sizes, so I bought the "large" size. Here's the question - should I build up the butt size with fiberglass to match the recoil pad standard size, or should I grind the pad to match the butt size? Is there a way to grind the pad that will produce a result that looks good -even great? At this stage I've also been advised to embed about 1&1/2 lbs of lead shot in the stock. This will supposedly reduce recoil (the gun is a 308). I will not be "packing" the gun for long distances and want to use it primarily at the range and plan to shoot 100-200 rounds/afternoon. It originally had a metal butt plate and 100-200 rounds results in just a bit much soreness on Monday morning for this guy. Thanks for any suggestions. Bill
Bill Hebert is offline  
Old July 16, 1999, 03:34 PM   #2
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 17,057
Generally in fitting a recoil pad, the pad is ground to fit the contours of the stock. Tape up the stock to protect it from the sander. Two layers of tape should do nicely. Go slow and inspect often.

------------------
Vigilantibus et non dormientibus jura subveniunt


4V50 Gary is offline  
Old July 16, 1999, 09:05 PM   #3
Grayfox
Senior Member
 
Join Date: December 17, 1998
Posts: 1,885
Gary told you right. Here's a little trick I use. Two layers of tape using different colors or types of tape. When the top layer is gone, close enough.

Heed the warning. Go slow, inspect often. It only takes one small slip to leave a nasty mark on the stock.
Grayfox is offline  
Old July 16, 1999, 10:48 PM   #4
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Bill, I'll only add a little to what Gary and Grayfox have already said. I'm assuming that you don't have a recoil pad jig. It wouldn't be worth it for one pad anyway. If I were installing one for the first time without a jig I would use a disc sander and get no closer than 1/16" to the stock. At that point I would wrap with two thicknesses of tape as Grayfox suggested and finish with a sharp file and abrasive strips.
George Stringer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:02 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06843 seconds with 9 queries