The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 6, 1999, 04:41 PM   #1
Macoute
Member
 
Join Date: October 9, 1998
Posts: 24
I am in the market for a used revolver and want to make sure that i am testing the timin correctly. These are the techniques that I know to check the timing on a S&W.

1. If it is DA/SA, thumb cock the hammer on each cylinder. The cylinder stop should lock into the groove on the cylinder prior to the hammer locking into position for SA fire.

2. Load the cylinder with armorer's dummies. Dry fire the revolver on all six shots. Between each shot, check the cylinder to ensure that it is locked with the cylinder stop.

Are these techniques valid, is one better than the other, are there better ways to test? Thanks.
Macoute is offline  
Old July 7, 1999, 09:27 AM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Macoute, you have the last area to look for in your timing check pretty well down. But, you also need to make sure that the beginning of the timing cycle is correct. Hold the cylinder lightly just to add a little resistance, pull the trigger and observe the action of the bolt and the hand. The bolt should drop free of the cylinder before the hand begins to turn the rachet. George
George Stringer is offline  
Old July 7, 1999, 11:00 AM   #3
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,127
Also, do a quick eyeball check of the barrel cylinder gap; it should be .004 -.006. (Your eyeballs are calibrated to .001", aren't they? Actually, when you look at a few guns, you can actually tell, without a gage.) On a heavy caliber gun, check the rear of the barrel for cracks. Check that everything works OK in both DA and SA.

Good luck.

Jim

James K is offline  
Old July 8, 1999, 10:33 AM   #4
burrhead
Senior Member
 
Join Date: July 6, 1999
Location: Chihuahuan desert, Texas
Posts: 401
In addition to what's been said above I also take a close look at the ejector rod and side plate screws. If anything is boogerd, that means an amature has been in the gun's inerds and I pass on it. IMHO.
burrhead is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06805 seconds with 9 queries