The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old July 6, 1999, 10:29 AM   #1
flatlander
Senior Member
 
Join Date: June 16, 1999
Posts: 120
I traded for one of the Winchester M94 Centennial rifles with the 26" half octagon barrel, primarily because I'd heard that Badger Barrels made the barrel, and I wanted a good barrel to play with cast bullets in. Does anyone out there know if Badger did make these barrels, and if so, how good are they? I don't suppose that Badger had the budget or the time to hand lap these production barrels like they would one of their custom target barrels, so I might consider firelapping it with the finer(800-1200 grit) grades of abrasive. Any opinions?

[This message has been edited by flatlander (edited July 06, 1999).]
flatlander is offline  
Old July 6, 1999, 11:42 AM   #2
Paul B.
Senior Member
 
Join Date: March 28, 1999
Location: Tucson, AZ
Posts: 2,695
Flatlander. I don't know who made the barrels for your rifle. I do shoot a lot of cast lead from 30-30's. It's one of my favorite cartridges. Using 10 parts wheel weights, mixed with one part linotype, I duplicate factory loads with no problem. I use Lyman #311291 and 31141 (now called 311041). The load I finally settled on duplicates the origional 30-30 load of 1965 fps. I does a number on deer. When duplicating current factory loads, the mushrooms and retained bullet weight are almost exactly the same as Federal 170 gr. loads. I just picked up a Canadian Centennial myself, but I haven't had the time to shoot it yet. Got to find a peep sight for it and with my eyes, I can see the rear sight, and the target, but not the front sight. One of the problems of old age and those new-fangle varilux lenses. I hope your Centennial works out for you.
Paul B.
Paul B. is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:51 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05702 seconds with 7 queries