The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old April 17, 1999, 03:03 PM   #1
Mikey
Senior Member
 
Join Date: November 14, 1998
Location: Tennessee
Posts: 885
I've got an STI frame and slide along with Nowlin ramped barrel etc., that I was going to have a local pistolsmith fit for me. The gun will be an IDPA competition piece. I only need the slide/frame/barrel fitting done since I usually fit the safeties and such myself.

But alas, my gunsmith is unavailable. I talked to the smith at STI and he says he can do the job - same as the STI Short Block - and I'll be on my way.

The question is...has anybody had any experience with STI smithing? I'm kind of picky about the slide to frame fit and really picky about barrel fit. The guy sounds like he's ok and he does the slide/frame sets for STI. Anybody got an opinion??

Mikey
Mikey is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:39 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06098 seconds with 7 queries