The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 30, 1998, 09:38 AM   #1
BIG JOHN
Junior Member
 
Join Date: November 12, 1998
Location: Manchester,TN 37355
Posts: 6
I ran into a new problem that I have not encountered before. During EXTREME rapid fire, this 1911 stlye gun will fail to keep the hammer cocked! Any suggestions?
BIG JOHN is offline  
Old November 30, 1998, 11:59 AM   #2
Doc Lisenby
Member
 
Join Date: November 25, 1998
Location: Chesterfield, SC,USA
Posts: 31
Bigun, for a start, either bend the middle leaf of the sear spring forward or replace the spring. As a retired military armorer, I have seen this which we described as "hammer follows slide forward" type malfunction. It may be caused also by the slide binding when firing rapidly due to heat which prevent incomplete retraction of the slide but this usually leads to incomplete ejection. A heavy recoil spring will cause the same symptom. If this is not a "blueprint" slabside, you may have a defective disconnector. If all else fails, take it up to George Stringer, he is just over the border in "Kaintuck". He's on every gun link, including this one. He can almost make a "ferin" "45" like a government model.
Doc Lisenby is offline  
Old November 30, 1998, 08:50 PM   #3
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Big John, Doc pretty much covered it. I would suspect the sear spring as the most likely culprit. If after adjusting the sear spring it still follows, either post again or e-mail. George

------------------

George Stringer is offline  
Old November 30, 1998, 08:57 PM   #4
BIG JOHN
Junior Member
 
Join Date: November 12, 1998
Location: Manchester,TN 37355
Posts: 6
Thanks Doc & George. The gun belongs to a friend and will pass this info on! Big John
BIG JOHN is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:42 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07287 seconds with 9 queries