The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 23, 1998, 04:00 PM   #1
JohnN
Member
 
Join Date: October 23, 1998
Location: Indiana
Posts: 16
I have a new Remington 870 synthetic stock which I would like to round the top of the recoil pad. How is that best accomplished by an amateur?

Thanks,
John
JohnN is offline  
Old November 24, 1998, 08:50 AM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Veeery Carefully. But, that applies to experienced gunsmiths as well as a novice. Decide exactly what line you want to change and mark it if possible. If you want to leave the pad on the stock while you do this, wrap masking tape around the wood to protect against slips. Cut some strips of medium grit sandpaper and use sort of a shoeshine motion on the area concerned. George

------------------

George Stringer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:32 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05287 seconds with 7 queries