The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old October 14, 1998, 08:43 AM   #1
DEC
Member
 
Join Date: October 13, 1998
Location: Dillsburg, PA, U.S.A.
Posts: 76
I'm thinking about getting my pistol re-finished. Does anyone out there have any experience with Black-T, Robar, GunKote, etc.? Please let me know how you like the finish. One more question, do I need to break in the pistol before I get it re-finished?

Thanks
DEC is offline  
Old October 14, 1998, 06:12 PM   #2
Mac Scott
Member
 
Join Date: October 6, 1998
Location: Cotati, CA USA
Posts: 37
Dec,

I was hoping someone else would answer your query since I'm in the business and don't want to appear as if I'm trying to promote same on this forum.

However, since no one's jumped in in the past eight hours or so, I'll take a small (as in "short") stab at it.

In my experience any type of coating that is applied by either dipping or spraying and then "baked" on does two things:
1. It protects very well against the elements, against salt, in general against corrosion.
2. It is very susceptible to abrasion from sharp objects. Moreover, sharp edges on the arm will undoubtedly wear thin on repeated contact with leather and the like.

The above applies to virtually all the coatings out there, including Black-T, GunKote, Roguard, GnomeKote -- just about all of 'em. This isn't to say they're bad finishes, 'cause they aren't -- they really do protect the gun from rust and corrosion, which is what they're intended to do, much more so than bluing or the like. But, like bluing, they tend to show wear and tear which, to some people, is anathema. Those who live with the gun as a tool, however, generally tend to overlook such esthetic problems in light of the overiding benefits provided.

Plating generally tends to be quite a bit tougher, but it looks like....er...plating! And, if something does pierce plating's surface, the entire item generally must be stripped to reapply the plating. The teflon/molybdenum/whatever finishes can usually be reapplied directly over the previous finish with no degradation.

Anyway, a short bit of one person's insight into the situation. Opinions vary, just like your mileage (grin).

----Mac
Mac Scott is offline  
Old November 14, 1998, 12:43 PM   #3
Bennett Richards
Senior Member
 
Join Date: November 14, 1998
Location: Carlsbad, CA USA
Posts: 343
How do NP-3 and the new Wilson's Armor Tuff finishes compare to Roguard, Bear Coat etc?
Bennett Richards is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:24 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06292 seconds with 7 queries