The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old November 9, 1998, 11:41 AM   #1
buck40
Junior Member
 
Join Date: October 30, 1998
Location: Wamego, KS. USA
Posts: 12
I bought a Ceiner 22 conversion kit for my Colt Commander (lwt version - but not marked as so). The conversion slide won't go past the ejector. It doesn't seem to be notched quite as wide as the 45 slide - I measure about 3 thousandths difference. My ejector is loose and poorly fitted.

Can I get a different style of ejector to work reliably with both slides or should I abandon the project?

Thanks
Buck Peddicord
buck40 is offline  
Old November 10, 1998, 12:02 PM   #2
George Stringer
Staff Alumnus
 
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
Buck40, when you put the slide on the frame, take it back as far as it will go then hold it up with the muzzle toward a light source. If you can't see light all around the ejector a little judicious filing is in order on the outside of the ejector itself. If you can see light, the problem lies in the frame rail slot at that point. It might be that your ejector pin is protruding a little and just needs to be drifted back into place or you may have to lap the slide to the frame. George
George Stringer is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:22 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06181 seconds with 7 queries