The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old October 12, 1998, 07:42 PM   #1
Cletus
Junior Member
 
Join Date: October 11, 1998
Location: Old Bridge, NJ
Posts: 3
Win. says front and rear 35 in lbs or less , center screw 25 in lbs or less. How do you know when you are at proper tension without a torque wrench? Any other suggestions for tightening the screws?
Cletus is offline  
Old October 26, 1998, 11:41 AM   #2
chargar
Member
 
Join Date: October 15, 1998
Location: Texas
Posts: 23
Tighten the front and rear screws as tight as you can get them by hand with a proper fitting screw driver. It is even alright to use two hands on the driver. Too much pressure on the middle screw will cause accurcy problems. Just snug up the middle screw. Turn it slowly with one hand and when it stops turning quit! That should solve your problems.
chargar is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:57 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05118 seconds with 7 queries