The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Reply
 
Thread Tools
Old September 1, 2005, 02:53 PM   #1
Bert223
Member
 
Join Date: May 23, 2005
Posts: 77
ruger m77 laminate stock question

Hi,

I sanded out part of the barrel channel on my ruger m77 laminate stock and I was wondering if you guys could recommend a good finish to put in the barrel channel like laquer or stain or any other procedures that I should do to make the stock waterproof again? I appreciate any advice. As a side note the gun went from about 2 inch groups at 100 yards to about 5/8" groups just sanding down the front part of the barrel channel to make the barrel fully free floating.
Bert223 is offline  
Old September 2, 2005, 12:08 AM   #2
cntryboy1289
Senior Member
 
Join Date: July 19, 2004
Location: Ms
Posts: 1,160
Spar varnish

Most any hardware supply should have a spar varnish. It might say spar urethane. I use it on barrel channels occasionally. I prefer to use Arrow's wood finish since it is a sealer, filler, and waterproof oil finish and I use it on the rest of the stock as well.
cntryboy1289 is offline  
Old September 2, 2005, 07:44 PM   #3
Bert223
Member
 
Join Date: May 23, 2005
Posts: 77
Cool, thanks for the tip I'll give it a try.
Bert223 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:59 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05978 seconds with 7 queries