The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Thread Tools Search this Thread
Old August 28, 2005, 07:24 PM   #1
Senior Member
Join Date: August 17, 2005
Location: Stillwater Oklahoma
Posts: 698
taper crimp die

found some dillon diea at a pawn shop without int. the nuts are't locking
looks like the seater and sizing dies are made to touch the shellholder
what about the crimp die ?
Toney is offline  
Old August 29, 2005, 09:35 AM   #2
Senior Member
Join Date: May 29, 2004
Posts: 145
Toney, follow the above link. It may be of help to you in setting up the dies. They show the dies being set-up on the Dillon machines but the same procedure, I believe, can be used on any press. Do the dies screw into your press? If not, they are probably SDB dies. If you're still stumped just call or email Dillon and they'll help you out.
crazylegs is offline  
Old August 30, 2005, 07:19 AM   #3
Senior Member
Join Date: January 1, 2000
Location: Roanoke, Virginia
Posts: 2,678
Dillon Dies

I can not comment of Dillon Dies...
All a "Taper Crimp die" is a sizing die with the decapping stim removed and readjusted to bring the case mouth around the bullet. Lee and Hornady dies give a lot of trouble getting the decapping stim back in place so, you are better off buying a used Lyman, RCBS etc. sizer die...
MADISON is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:56 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.15634 seconds with 7 queries