The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Reply
 
Thread Tools
Old June 12, 2005, 04:51 PM   #1
kirkcdl
Senior Member
 
Join Date: December 14, 2002
Location: Roseburg,ORYGUN
Posts: 818
Kahr K40 question

I own a K40,and I read somewhere that the"Elite"version of that gun had work done at the factory to shorten the otherwise longish trigger pull.I emailed Kahr and was told there was no way to do that.I think perhaps they were just doing a little CYA.I don't want to lighten the pull,just shorten it a bit.Anyone know how this is done?Perhaps by comparing side by side schematics of the two guns,and replacing parts that are different in the trigger mechanism?Ideas,anyone?Thanks in advance...
kirkcdl is offline  
Old June 12, 2005, 06:28 PM   #2
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,824
The "Elite" trigger is a matter of fitting different parts, NOT altering or adjusting.

In other words, if you want an Elite trigger assembly, you have to buy the parts, and have a qualified pistolsmith install them.

The difference in length of pull really isn't that much, and many people actually prefer the longer standard trigger because if feels so much like a well-tuned S&W revolver trigger.

Bottom line is, the Elite trigger is not like going from a revolver to a Glock trigger.
You will have a SLIGHTLY shorter trigger, not a radically shorter trigger.

If you really want an Elite trigger, contact Kahr and ask about INSTALLING an Elite trigger assembly.
Dfariswheel is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:27 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06125 seconds with 7 queries