The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old June 12, 2005, 11:27 PM   #1
Texgun
Member
 
Join Date: June 12, 2005
Posts: 16
Marlin 444

Is the Sierra .4295 made for .444 Marlin? I just tried loading today for the first time and they are loose in the brass. I can move the bullets with my fingers. Is that bad?
Texgun is offline  
Old June 12, 2005, 11:44 PM   #2
Leftoverdj
Senior Member
 
Join Date: October 15, 2004
Posts: 934
That's bad, Tex. Bullets are big enough. First thing to try is to take a sized case, flare the case mouth the least bit with anything tapered and handy, charge the case, and seat the bullet in the seating die. If that bullet is tight, your expander is too big. If it's loose, your sizer is too big. Either way, the die maker should make it right.

Brass may be a bit on the thin side, but the sizer should be tight enough to allow for that.
Leftoverdj is offline  
Old June 14, 2005, 09:18 PM   #3
Ben Shepherd
Senior Member
 
Join Date: August 11, 2001
Location: Utah
Posts: 1,462
Your bullet diameter is correct.
__________________
From my cold dead hands.........

NRA certified rifle, pistol and shotgun instructor.
Hunter education instructor
Ben Shepherd is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:13 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06229 seconds with 9 queries