The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old May 26, 2005, 05:07 PM   #1
Clone
Senior Member
 
Join Date: March 16, 2005
Posts: 229
Over Seated 45ACP +P???

i have a aguila IQ 117gr +p round that i droped while it was sticking out of a mag and it seem to have over seated about 1mm. Will it hurt to fire an over seated aguila 117gr 45 +p? Its not really noticable until u place it next to another round, but i was thinking it could cause problems in pressure's being that it is an high pressure load to begin with.
Clone is offline  
Old May 26, 2005, 06:13 PM   #2
mete
Senior Member
 
Join Date: June 14, 2004
Location: NY State
Posts: 5,284
Pushing a bullet back into the case does raise pressures and is responsible for some Kabooms. If you push back a bullet in a .40 by .10 " you will double the pressure from 35,000 to 70,000psi. A 45 is a bit better especially a steel frame gun, since the operating pressures are lower.
mete is offline  
Old May 27, 2005, 10:29 AM   #3
crazylegs
Senior Member
 
Join Date: May 29, 2004
Posts: 145
I wouldn't fire it.
Crazylegs
crazylegs is offline  
Old May 27, 2005, 07:32 PM   #4
HighVelocity
Senior Member
 
Join Date: January 1, 2005
Location: DFW, TX
Posts: 220
throw it in the trash and don't buy any more of that ammo. The aguila ammo is very much hated on the 1911 forum and the general consensus is that it's very poor quality and low performing.
HighVelocity is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:19 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05965 seconds with 7 queries