The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Hunt

Closed Thread
 
Thread Tools
Old September 3, 2000, 05:09 PM   #1
Big Bunny
Senior Member
 
Join Date: August 9, 1999
Location: New South Wales - Australia
Posts: 605
When hunting with a U/O CZ break action gun (.223/12ga) last w/end, in a restricted dug-out under a camo net, under pressure (and excitement ..shooting crows!)_I briefly touched the under rifle barrel on the dusty dugout dirt wall. I immediately broke the CZ and inspected the rifle/shotgun barrels. But as it was still dawn, I failed to see that while the barrel was free and safe to continue hunting with, some fine red aussie dust had lodged in the neck/chamber area of the .223 barrel. On subsequent firing at a 50m plus crow(out of range for the 12GA) - the taped head new factory brass PMC case was expracted and was found to be covered in a fine "casement" of compressed dust on one side and also the neck area, slightly marking the new brass in places... a bit like unburned powder granules.
Well, I don't like this - even though pressures were low(55gn Rem SP and 23gn Mulwex 2208 CCI primer for 2,800FPS on initial short-range loading)and no signs of pressure were seen on the case/primer with a magnifier.

Questions and comments please....

1/.Could I have damaged the firearm in any way(it looks AOK after cleaning).
2/ Would taping the muzzle with thin scotch-tape be OK to prevent this happening again? I have done this on a W.30/30 in thick bush after pigs, but not in higher velocity firearms. It is very constricted inside my hide and some shots are taken at varying positions, often with some difficulty on wily corvids - even with a 24" barrel!

Your comments please - fellow hunters.

------------------
If we shooting sportspersons don't hang together... we will all hang separately !
Never knock another's different shooting interest or discipline...REMEMBER we are all but leaves on the same tree of freedom.
Big Bunny is offline  
Old September 5, 2000, 07:27 AM   #2
Art Eatman
Staff Lead
 
Join Date: November 13, 1998
Location: Terlingua, TX, USA
Posts: 22,540
The odds are that if it looks okay, it *is* okay. I'd check the crown of the muzzle on general principles, for dings--although the odds are in your favor.

Scotch tape is as good an idea as baloons or condums...

FWIW, Art
Art Eatman is offline  
Old September 5, 2000, 10:49 AM   #3
Al Thompson
Staff Alumnus
 
Join Date: May 2, 1999
Location: South Carolina
Posts: 3,605
BB, I'm sending this to the Art of the Rifle forum, see if we can get some more opinions.

Giz
Al Thompson is offline  
Closed Thread

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:40 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07275 seconds with 9 queries