The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old April 11, 2005, 08:30 PM   #1
Bass Man
Member
 
Join Date: December 26, 2004
Location: Missouri
Posts: 92
75 grain v-max in the 6mm rem

I loaded some 75 grain v-max in my 6mm rem. I tried the overall length method of putting it in the chamber long and gradually seating it deaper until there were not any more scratches. I checked it after a few tries and the calipers said it was way under the min. legth in the manual of 2.790. For further info I used 38 grains of reloader 15. Is there maybe something else that is leaving these marks on the bullet instead of the lands? I did steel wool the bullet each time I tried it.
Bass Man is offline  
Old April 14, 2005, 10:09 AM   #2
capnrik
Senior Member
 
Join Date: September 29, 2000
Location: Texas
Posts: 474
If you have a handload that measures under the published overall length, it shouldn't be contacting the rifling. Have you loaded for this rifle in the past?
__________________
All rights reserved.
capnrik is offline  
Old April 14, 2005, 08:04 PM   #3
MLC
Senior Member
 
Join Date: October 9, 2001
Location: New Hope, PA
Posts: 230
The action could be scraping the bullet on the way into the chamber.
I've found that the bullets drags a bit as you push it into the chamber in both of my 700's.
MLC is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:36 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06396 seconds with 7 queries