The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old January 25, 2005, 06:08 PM   #1
BigSlick
Senior Member
 
Join Date: January 25, 2005
Location: Texas of course
Posts: 277
550B - 50 AE / 500 S&W seperate seat/crimp solution ??

Hi guys,

I am looking for an alternative to performing the seat/crimp in one die.

With the 500 I bought 2 sets of dies. I seat with one die (no crimp), and removed the seat plug from the other die for crimp only. This works, but sucks having to buy two sets of dies.

I am facing the same thing with 50 AE and hoping to find another solution.

I thought about buying an additional sea/crimp die only, but I can buy a die set for cheaper than one die from RCBS or Redding. Dillon doesn't make dies for either.


Amy ideas ?

Thanks

BigSlick
BigSlick is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:15 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.05507 seconds with 7 queries