The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old November 4, 2004, 03:32 PM   #1
FirstFreedom
Junior member
 
Join Date: May 31, 2004
Location: The Toll Road State, U.S.A.
Posts: 12,451
Quick dumb question

I bought some Hornady .270 dies on an impulse purchase recently, but before I open the package - they will work in my Dillon RL450, with appropriate doo-dads from Dillon, right? I'm 99% sure, but wanted to check...
FirstFreedom is offline  
Old November 4, 2004, 06:08 PM   #2
Ultima-Ratio
Junior member
 
Join Date: May 18, 2004
Location: Anchorage Alaska
Posts: 227
Yep!

I believe all the current production reloading dies are standarding to 7/8-14 (?) I havn't seen the smaller diameter in years, was it Pacific?
Ultima-Ratio is offline  
Old November 5, 2004, 04:34 PM   #3
Leftoverdj
Senior Member
 
Join Date: October 15, 2004
Posts: 934
Should. The thread is standard as has been said. There were some compatibility issues with Dillon presses and Lee dies years ago, but Lee has made the threaded portion longer in their current dies. Never heard of any problems with Hornady's.
Leftoverdj is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:12 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06873 seconds with 7 queries