The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old October 11, 2004, 12:49 AM   #1
FHKPLEX03
Junior Member
 
Join Date: June 26, 2004
Posts: 9
Rem. 11-48 Ejection prob.

I've recently inherited 2 Remington 11-48 12 gauges. One of them began hanging up upon ejection a few years ago and has progessively become worse. I have completely disassembled both, cleaned all parts/mechanisms, applied a light lubricant to the tube which the spring covers, yet one of them still cannot fire without the empty cartridge hanging up halfway out the ejection opening. It hangs up 100% regardless of load being fired (even high brass.) Could the spring simply be worn out? If so, is this a part regularly available? If not the spring what are other possibilities? I would appreciate any suggestions/advice.
FHKPLEX03 is offline  
Old October 11, 2004, 10:09 AM   #2
K80Geoff
Senior Member
 
Join Date: December 20, 1998
Location: NE Pennsylvania
Posts: 3,640
I'll take a poke at this. I do not own an 11-48 so do not know the little idiosyncracies the guns may have. Of course not seeing the actual gun is not the way to find the problem. Since you have two similar guns and one works and the other malfunctions with the same ammo, the problem is the gun. Probably some part needs to be replaced or worked on.

Could be the extractor or possibly the bolt return spring.

Try working the mechanism with a snap cap in the good gun, then in the bad one to see if anything is different. IE the extractor may be out of spec or bent or worn.

Try replacing the recoil spring to see if that helps.

Take out the bolt in both guns and carefully examine them for differences, remembering of course which is the good bolt

Check all parts for burrs, peening, wear or badly fitting parts.

Was the gun owned by a Trapshooter? Maybe he engineered the gun not to toss the empties?


If all else fails see a competent gunsmith, or even try calling Remington.

http://www.e-gunparts.com/productsch...odel=0860z1148
__________________
I am no longer a member of this forum. Bye!
K80Geoff is offline  
Old October 11, 2004, 07:45 PM   #3
FHKPLEX03
Junior Member
 
Join Date: June 26, 2004
Posts: 9
I've compared the parts and notice no obvious differences in wear nor anything that appears to be excessively worn. The shotguns haven't been altered by either owner. The functioning shotgun was owned by my grandfather and the non-functioning by my dad. They were primarily used for squirrel, duck, and dove hunting. Anyone know of a Houston area store where I can pick up a recoil spring? I've been guessing this is the culprit part and it doesn't look to be an expensive replacement.
FHKPLEX03 is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:23 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07487 seconds with 7 queries