The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Harley Nolden Memorial Institute for Firearms Research

Thread Tools
Old October 5, 2002, 11:11 AM   #1
4V50 Gary
Join Date: November 2, 1998
Location: Colorado
Posts: 17,954


Do you have instructions for detailed stripping of this gun? Thanks,

Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
Old October 5, 2002, 11:28 AM   #2
Walt Sherrill
Senior Member
Join Date: February 15, 1999
Location: Winston-Salem, NC USA
Posts: 5,247
The gun is pretty straight-forward and the only tricky part I've found has to do with the safety. (Another shooter on THIS forum tipped me off and gave instructions.)

There is a small coiled spring inside the safety lever on the gun, and if you get that accidentally apart, there's he** to pay getting it back together.

Using a paper clip or small piece of wire insert the end of the clip/wire into the small hole on the safety, and move it around until it engages a second hole/detent inside the unit.

You can then remove the safety without problem.

You'll want to be sure the pin stays in place while the safety is set aside (as you diassemble the rest of the gun).
Walt Sherrill is offline  

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:39 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.05095 seconds with 9 queries