The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old September 9, 2002, 12:25 PM   #1
Freightman
Senior Member
 
Join Date: August 6, 2002
Location: NW Texas
Posts: 167
What is

the advantage of sealing the primmers?
I was told that I should be sealing mine, if it is for humity I live in a simi desert area.
I would be intrested in finding out why.
__________________
Freightman
Freightman is offline  
Old September 9, 2002, 12:36 PM   #2
jjmorgan64
Senior Member
 
Join Date: August 8, 2001
Posts: 519
Can be handy if you aim to carry your rifle with you while you're swimming, or in the shower.

Chances are you don't need to. A lot of Military stuff is sealed, but that is intended for long storage and harsh conditions.

If you decide to clear nail polish is simple and works well.
__________________
The Forty-Four spoke and it sent lead and smoke
And seventeen inches of flame. -Marty Robbins

JM
jjmorgan64 is offline  
Old September 9, 2002, 01:58 PM   #3
sleeping dog
Senior Member
 
Join Date: March 2, 2000
Location: MI
Posts: 536
I don't know what is considered NW Texas, but I remember El Paso (Fort Bliss) and I doubt if the humidity there would require sealed primers.

Who told you it was necessary?

jjmorgan got it right. Military ammo is sealed because it could spend a long time in the open during monsoons in SE Asia (Philippines, Burma, Vietnam, to name a few campaigns). Then we're glad we paid the extra money to have it sealed.

Regards.
sleeping dog is offline  
Old September 9, 2002, 02:12 PM   #4
Southla1
Member In Memoriam
 
Join Date: March 19, 2000
Location: Jeanerette, La. Near the
Posts: 1,999
I can promise you that in either NW Texas or the El Paso area no sealing is necessary.......................it isn't necessary here in South Louisiana which is probably one of the most humid places in the USA and I know for a fact that the afore mentioned areas are less humid. I have never sealed one in my life and never had a failure even living down here.
Southla1 is offline  
Old September 9, 2002, 03:36 PM   #5
sricciardelli
Senior Member
 
Join Date: August 13, 2001
Location: Montana
Posts: 489
None, unless you are in a combat situation, or you are loading Bang-Stiks for SCUBA divers.
__________________
http://stevespages.com/page8.htm
sricciardelli is offline  
Old September 10, 2002, 12:27 AM   #6
labgrade
Member In Memoriam
 
Join Date: November 29, 1999
Location: west of a small town, CO
Posts: 4,346
Ditto = no sealing required unless under the most harsh conditions OR, if you may.

Life-threatening? betcha, why not? & same-same for that hunt of a life-time. Again. Why not?

That said, I've never sealed a primer & have hunted The Glades - west. Never a malfunction, 'cept once & that had nothing to do with sealing a primer - just a funky one.

BTW, if you do the powerhead bit doing SCUBA, seal the bullet too.
labgrade is offline  
Old September 10, 2002, 01:26 AM   #7
Cal4D4
Senior Member
 
Join Date: June 18, 2001
Location: southern california
Posts: 679
I have had one squib that may have been caused by an unsealed round going from a warm pocket into a puddle of slush. If you don't intend on dropping them in water, sealing is probably just extra work.
Cal4D4 is offline  
Old September 10, 2002, 10:28 AM   #8
Poodleshooter
Senior Member
 
Join Date: August 7, 2000
Location: Floating down the James River in VA
Posts: 2,541
Do it for hunting ammo, but for anything else, it's a waste of time.
Poodleshooter is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:02 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07604 seconds with 9 queries