The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old August 21, 2002, 10:21 PM   #1
Edward429451
Junior member
 
Join Date: November 12, 2000
Location: Colorado Springs, Colorado
Posts: 9,494
Case neck lubing?

Should I be lubing the inside of case necks when reloading? I haven't been but wonder what advantage it is, or the potential downfalls are if I don't. Does this just extend the life of the expander ball or what?

Proper lube, proper application method?
Edward429451 is offline  
Old August 22, 2002, 05:37 PM   #2
cheygriz
Senior Member
 
Join Date: May 11, 2002
Location: high up in the rockies
Posts: 2,232
There is a bit of debate on this. I tried it and didn't see any improvement.

I also tried wrapping 0000 stell wool around a worn our bronze cleaning brush and hand turning it in the case neck to clean out the residue. That made it easier to pull the case over the expander ball, and easier to seat the bullets, but it didn't help accuracy or consistency.

A carbide expander ball in your sizing die seems to work better than anything else that I've tried.

Cleaning or lubing case necks get to be a real pain when loading in batches on 1,000 or 2,000 rounds like you do for .223 and .308.

Now, I just wash the brass in a rotary tumbler with warm water and liquid Tide, (a vibratory tumbler with corncob or walnut works almost as well) and I just load them without any more prep.

If you do lube case necks, and I don't recommend it, use only powdered mica or powdered graphite. Don't use grease, oil or wax.

Then, on the other hand, there are those who will disagree strongly with what I have just written.
__________________
If you think a mighty military force is expensive, wait 'til you see what a weak one costs.
cheygriz is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:39 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07459 seconds with 7 queries