The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools
Old June 24, 2002, 01:49 AM   #1
Zak Smith
Senior Member
 
Join Date: December 12, 1999
Location: Fort Collins, Colorado, USA
Posts: 2,675
Barnes XPB results ?

Anyone have experience with Barnes "XPB" bullets for handguns? I am looking at the 200 and 225gr's for .44.

These bullets are made of a copper alloy, with no lead, and have a very deep hollow-point, and a "solid" base. As a result, they take up more space for the same bullet mass, meaning less internal volume available for combustion. I loaded some up with 7.5gr Unique and accuracy was about the same as Hornady XTP's.

Has anyone seen any terminal ballistics for these bullets?

thanks
Zak
Zak Smith is offline  
Old June 24, 2002, 04:53 AM   #2
WESHOOT2
Senior Member
 
Join Date: February 20, 1999
Location: home on the range; Vermont (Caspian country)
Posts: 14,123
NEVER EVEN TRIED THEM

If I need premium jacketed I use Swift A-Frames; all other 'penetrating' loads utilize some sort of (beautiful) heavy lead bullet.

IMNSHO the Barnes leave me slightly suspect due to the lack of a lead (or heavy metal) core; concerned about 'true flight' and 'straight penetration'.
Zero worries with the Swifts or lead.............

Maybe the Barnes work great on thin-skinned or non-biting creatures.
__________________
.
"all my ammo is mostly retired factory ammo"
WESHOOT2 is offline  
Old June 24, 2002, 11:19 PM   #3
labgrade
Member In Memoriam
 
Join Date: November 29, 1999
Location: west of a small town, CO
Posts: 4,346
Zip experience with anything Barnes except their 165 XBT in .30 cal at 2400 fps.

"Good enough" accuracy = ~1"++ 3-shot groups at 100 & no signs of tipping past 300 yds. 300 yd groups around 4-5", & some of that's me. My "low-velocity" bullet of choice for elk.

Ballistic Coefficient is very high due to the added length-for-weight, but as you mentioned, a bit of a internal case volumne loss associated.

All mine's been rifle-stuff ... & with excellent results.

Too, I've heard of the bullets not obturating to the rifling due to the "hard" cpper/solid bullet. The metal is annealed to proper hardness & does - all have full-groove rifling that I've shot.

As with any compenent change, always work up from known data.

Actually, for a .44/.45 cal-class handgun I'd not spend the big $s using such a premium bullet, unless for a .44 special level SD loading, or similar. A hard-cast bullet will shoot through almost anything reasonable & kill it just as dead as a $.50 bullet will.
labgrade is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:39 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06823 seconds with 7 queries