The Firing Line Forums

Go Back   The Firing Line Forums > The Hide > The Dave McCracken Memorial Shotgun Forum

Reply
 
Thread Tools
Old April 10, 2000, 01:02 PM   #1
Oleg Volk
Staff Alumnus
 
Join Date: December 6, 1999
Location: Nashville, TN
Posts: 7,022
In cleaning the cylinder bore of my 20ga Winchester 1300, I noticed a "dimple" right under the bead (dimple on the inside of the bore). Couldn't tell if it was part of the design...if it is, wouldn't that mess up the slugs and shot cups as they come out?
Oleg Volk is offline  
Old April 10, 2000, 05:08 PM   #2
Dave McC
Staff In Memoriam
 
Join Date: October 13, 1999
Location: Columbia, Md, USA
Posts: 8,812
It's not just yours,Oleg, there's plenty like it out there. When they do the hole for the sight, sometimes it dimples the mestal underneath, sometimes it comes through. No damage,other than esthetically, and effect on slugs and wads is unknown but minor.
Dave McC is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:02 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.06175 seconds with 7 queries