The Firing Line Forums

Go Back   The Firing Line Forums > The North Corral > Competition Shooting

Reply
 
Thread Tools
Old March 29, 2002, 11:54 AM   #1
tator
Member
 
Join Date: February 12, 2001
Location: Minneapolis, MN
Posts: 81
Bullet Type for Steel Events

looking for bullet info for shooting steel events. Jacketed or lead?
bullet shape? Normal loads for the PF.


Thanks,

tater
tator is offline  
Old March 29, 2002, 01:14 PM   #2
eerw
Senior Member
 
Join Date: March 18, 2001
Posts: 395
I like jacketed just to keep the smoke down from the bullet lube..too many times I have shot withthe sun in my eyes and the smoke doensn't clear to see.

So I would pick what ones 100% reliable..be it round nose or JHP type bullet shape..and as for load..whatever it take..some steel matches are just mark them..others are knock down..which from the one I have shot are calibrated for 9mm or 125 PF..

good luck
eerw is offline  
Old April 1, 2002, 04:42 PM   #3
Norm Lee
Member
 
Join Date: January 3, 2001
Location: Nassau Bay
Posts: 79
for steel

Hey Tator:

I typed a long, informative, amusing, and detailed reply to your inquiry but it has apparently wound up in the bit bucket. I don't type all that well and at my age, short term memory is a problem, too so this won't likely be nearly as funny nor as useful.
But, anyway.
What sort of steel shooting do you contemplate?

If it's of the IDPA/IPSC sort, the steel will be set to fall for the lowest power loads allowed (PF=125). For some events PF is not relevant.

I recommend getting as close as possible to the minimum level as will produce a knock down reliably. Time spent hauling your gun back down out of the sky does not contribute favorably to your score.

I like to go about 135-145 which works well, and is pretty controllable, and usually will help to keep me from succumbing to the urge to wait to see What happens after I break a shot. That, too, is an activity that burns daylight to little avail.

I believe you should go with a lead bullet in WC or SWC shape. The flat points and edges will make a difference if your aim strays and you hit steel near an edge. Probability of favorable energy transfer is higher. Of course, if, like me, you keep your hits in the middle, it matters not.

Partial jackets and JHP are not allowed at some matches for their propensity to shed the jacket material which results in flying flak with too much velocity and way too many sharp and jagged edges on the range. FMJ is probably OK.

Lead bullets from Precision and some others do not have smoke producing waxy lubes. Smoke can be an issue for the faster shooters.

Cheers,

Norm
Norm Lee is offline  
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:28 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2014 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Contact Us
Page generated in 0.07103 seconds with 9 queries