The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > The Smithy

Thread Tools Search this Thread
Old March 23, 2002, 11:24 AM   #1
Senior Member
Join Date: February 14, 1999
Location: Eastern, PA, USA
Posts: 147
other possibility

Insert a rail connecting the front and rear of the channel that site below barrel and locks those voids together. A fairly siimply job for a milling machine. Figure around $50 - $75 at the localmachine shop.
An X is still an X with a Quarter Inch group at 100 yards
With a Quarter Inch Group on the keyboard an X could be - Z,S,D, or C.
I am a quarter inch typist - Please excuse the errors!
Riss is offline  

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:53 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2015 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent:
Contact Us
Page generated in 0.08429 seconds with 7 queries