November 18, 2008, 04:53 AM | #1 |
Senior Member
Join Date: February 4, 2006
Posts: 206
|
Mini-Mauser rebarrel
Anybody found a standard thread that will work for the mini-mauser?
I'm trying to get out of resetting my lathe to cut metric threads. It's a pain having to cut threads by starting and stopping without disengaging the half nuts. |
November 18, 2008, 12:58 PM | #2 |
Senior Member
Join Date: June 16, 2008
Location: Wyoming
Posts: 11,061
|
Try this
__________________
Kraig Stuart CPT USAR Ret USAMU Sniper School Distinguished Rifle Badge 1071 |
November 20, 2008, 03:02 AM | #3 |
Senior Member
Join Date: November 13, 2006
Posts: 8,289
|
Assuming you are only threading one barrel,turn off the breaker or unplug the lathe,and turn the chuck by hand,forward and reverse.use a sharp tool and light cuts. Do back out before you back up.Yeah,there are drawbacks,but it works.you have great control over where the cut stops.Each cut,try to stop just barely shy of the previous chip so you don't snap off the tip of your cutter.Use a good lube.
|
|
|