September 20, 2011, 07:44 AM | #1 |
Senior Member
Join Date: August 16, 2007
Posts: 147
|
Benelli M4 SBS
Looking at SBS a Benelli M4 and wanted to know when you replace the 18" barrel with the 14" barrel what needs to be done to get the mag tube to work with the 14" barrel? Do you have to buy a mag specific length mag tube or what?
__________________
"When the people fear the govt there is tyranny, when the govt fears the people there is liberty." Thomas Jefferson |
September 20, 2011, 10:27 AM | #2 | |
Senior Member
Join Date: June 17, 2010
Location: Virginia
Posts: 6,869
|
Quote:
Someone else chime in here with their understanding of min barrel length under federal law. |
|
September 20, 2011, 10:33 AM | #3 | |
Senior Member
Join Date: December 21, 2009
Location: NJ
Posts: 727
|
Quote:
|
|
September 20, 2011, 02:14 PM | #4 |
Member
Join Date: July 6, 2007
Location: Georgia
Posts: 73
|
SBR'd M4
Although I've not considered doing this with my M4, you might check out the Benelli forums on the manufacturer's web page. There's an active vendor member named Carrier Comp and he does some slick stuff with the M4's with Ti mag tubes and some other stuff. You'll find your answer there and good luck.
|
September 21, 2011, 08:39 AM | #5 |
Senior Member
Join Date: August 16, 2007
Posts: 147
|
Yeah, I think after dealing with NFA items for several years I know what to do. I've tried to go to there forum but for some reason I can't get it to load. Will check back there and see.
__________________
"When the people fear the govt there is tyranny, when the govt fears the people there is liberty." Thomas Jefferson |
November 28, 2011, 02:43 AM | #6 |
Senior Member
Join Date: September 8, 2007
Location: Las Vegas Nevada
Posts: 174
|
The 14" will bolt right on. You would have to just remove the spacer/extender that is on your magazine tube right now...
__________________
FEAR NO EVIL |
Thread Tools | Search this Thread |
|
|