March 6, 2005, 04:33 PM | #1 |
Junior Member
Join Date: March 6, 2005
Posts: 2
|
Sporter p14 mag well
I recently purchased a P14 Enfield that is in a nice sporter stock. It has had the trigger guard/ floorplate modified to take the offset out. It unfortunately is missing the mag well. How much trouble is it to shorten a regular mag well to work with this modification. How much would a gunsmith charge to do this work?
|
March 6, 2005, 09:10 PM | #2 |
Junior Member
Join Date: December 12, 2004
Posts: 4
|
Not a difficult task.To do so,scribe a line around the bottom edge a 1/4" up and all the way around.This includes theshoulders at the ends.Than use a hacksaw and file to shorten the box that amount.
|
March 8, 2005, 03:15 PM | #3 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
Permit me to add to RayO's reply. Cut a bit overlong, and then work it down with a file, trying as you cut. It is a lot easier to take off metal than put it on, and you don't want the box rattling around.
Jim |
March 9, 2005, 10:08 AM | #4 |
Junior Member
Join Date: March 6, 2005
Posts: 2
|
Thanks for the advise. I have ordered a P14 mag well from Numrichs and will proceed slowly as advised.
|
|
|