|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
November 27, 2012, 07:29 PM | #1 |
Member
Join Date: November 17, 2012
Posts: 34
|
S&W 617 rear sight channel photo
Can anyone provide a photo of the rear sight channel top view in a 617 along with the rear sight components.
I am going to remove a weaver mount and reddot scope and would like to see what to expect when the mount comes off. Also I want to replace the blade with an aftermarket white out line blade. Looking at the rear sight (in an envelope assembled) I'm wonder what tool is available to hold the "nut while unscrewing the adjusting screw. It appears to have a spanner type nut, very small. I bought the gun with the scope mounted and want to pull it off and reinstall the adjustable rear with a new blade. I had planned to do a trade for the gun and just bought it outright and would rather have it without the scope initially. My old eyes may decide differently Thanks Tom |
November 28, 2012, 06:49 PM | #2 |
Senior Member
Join Date: October 19, 2008
Posts: 635
|
Here's an advertisement video that shows what you are looking for:
http://www.youtube.com/watch?v=ATwZg8jA648 |
November 28, 2012, 09:43 PM | #3 |
Member
Join Date: November 17, 2012
Posts: 34
|
Thanks I had seen the video what I'm puzzled about is there was no spring when the sight was removed and should there be.
Im hoping to see what the sight slot looked like before drilling and the spring location. Thanks again. |
November 29, 2012, 06:16 PM | #4 |
Senior Member
Join Date: October 19, 2008
Posts: 635
|
The only spring in a standard S&W sight is the tiny one in the windage adjustment. You would have to work to get that out, and it isn't in the frame but the sight assembly.
|
November 29, 2012, 08:56 PM | #5 |
Member
Join Date: November 17, 2012
Posts: 34
|
I removed the scope and put the sights back on. Ill shoot it tomorrw. The jury is still out on the Red Dot. Wish it had some magnification.
|
November 30, 2012, 11:00 AM | #6 |
Member
Join Date: November 17, 2012
Posts: 34
|
I took the red dot off and all is as I hoped it would be. There is no spring other than the bow in the sight frame. It all went together with no hitches. Thanks for the assistance though.
I've been investigating replacing the sight blade with an aftermarket white outline blade. that sounds a little "testy" removing and reinstalling the detent and spring, easily lost, and requires snapping the adjusting screw so a new screw must be purchased with the blade. I'll get there sooner or later. |
November 30, 2012, 12:33 PM | #7 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
The S&W sight is its own spring for sight elevation; the screw pulls it down instead of pushing it up. The little "nut" fits into a slot in the frame that holds it in place and keeps it from turning. You will see that when you remove the mount.
Jim |
|
|