July 21, 2001, 02:45 PM | #1 |
Senior Member
Join Date: April 6, 2000
Location: PA
Posts: 3,451
|
Astra 1916 Assembly
OK folks, I need a hand. I picked up a "project" gun, a little Astra 1916. Actually, I don't know if Astra actually made this gun, or it was a licensed copy. In any case, the slide says.
6.35 1916 MODEL AUTOMATIC PISTOL ASTRA PATENT It also has a Spain stamp, no surprise there. Now, for the problem. Although the exterior was in pretty good shape, probably 90-95%, the gun has not been cared for in a long time. I detail stripped it and cleaned all the surface rust off the pieces, and got it looking pretty good inside. I've just about finished assembly, when a problem surfaces. The hammer/sear spring is a leaf spring that has more strength than I have! It has to be compressed to slide under the sear and engage the hammer. I have not yet figured a way to do that! Any ideas? |
July 22, 2001, 01:27 PM | #2 |
Senior Member
Join Date: April 6, 2000
Location: PA
Posts: 3,451
|
Nevermind. I got it together, though I'm sure it wasn't the way that it was originally assembled! It was a PITA, so I cheated. Cute little pistol, now that it's a pistol again...
|
|
|