November 1, 2005, 05:20 PM | #1 |
Senior Member
Join Date: April 23, 2005
Location: Ohio
Posts: 422
|
Brass shavings
After trimming, chamfering, and deburring my brass I have some brass shavings left over inside so I clean them out the best I can with a small brush. Can the little shavings left over in the case affect the way powder burns or affect accuracy or even chamber pressures? I know its a very small amount...do I really have to worry about this at all?
__________________
"...and that's the bottom line, because Big Yac said so." |
November 1, 2005, 05:25 PM | #2 |
Staff
Join Date: March 20, 1999
Location: Somewhere in the woods of Northern Virginia
Posts: 16,955
|
"...do I really have to worry about this at all?" The short answer is no.
If you tap each case, mouth down, on a hard surface once you shouldn't have a significant amount brass bits left in the case. |
|
|