December 29, 2012, 08:45 PM | #1 |
Junior Member
Join Date: July 26, 2012
Posts: 5
|
Warped brass
Started reloading with Hornady New Dimension Die set. Forst time for rifle rounds. The seater die started doing this randomly. It's once fired military brass. I was crimping but backed off that but still does it. Any ideas on the cause?
|
December 29, 2012, 08:50 PM | #2 |
Senior Member
Join Date: October 18, 2006
Posts: 7,097
|
Your seater die is doing that randomly?
Either you didn't trim the brass uniformly and the seater die is impacting the extra brass... Or, your seater die is also a seater/crimp die and you are randomly bottoming out on an improperly adjusted die. My money is on the second option. Jimro
__________________
Machine guns are awesome until you have to carry one. |
December 29, 2012, 08:54 PM | #3 |
Junior Member
Join Date: July 26, 2012
Posts: 5
|
Thanks. Probably a little of both. I will start with readjusting the die.
|
December 29, 2012, 08:58 PM | #4 |
Senior Member
Join Date: March 1, 2009
Posts: 4,232
|
probably just the camera angle but those don't even look to be the same cases and bullets and the shoulder looks like it is curved
__________________
“How do I get to the next level?” Well, you get to the next level by being the first one on the range and the last one to leave.” – Jerry Miculek |
December 29, 2012, 08:58 PM | #5 |
Senior Member
Join Date: October 18, 2006
Posts: 7,097
|
To keep a seater/crimp die from crimping, use a nickel as a spacer. Put the ram in the up position, screw the die down to the nickel. That works with the Lee dies I've used.
Jimro
__________________
Machine guns are awesome until you have to carry one. |
December 30, 2012, 09:58 AM | #6 |
Junior Member
Join Date: July 26, 2012
Posts: 5
|
hounddawg, it's just the angle. jimro: I took the die apart, out it back together and set it for no crimp. This seems to have fixed the problem, thanks again
|
|
|