April 3, 2011, 05:40 PM | #1 |
Junior Member
Join Date: March 21, 2011
Posts: 8
|
Optics - AAArrrggg!!
Ok I am not limited when it comes to budget, but I am fairly thrifty.
My question is this; Is it possible to run an EOTech w/3x magnifier AND a gen 1 NV site along 1 rail. If so what would be the best order to run them in. Obviously the magnifier would go before the holo site, but I would also like to incorporate NV. Would it be better to run just a Trij ACOG w/ a NV scope? Should I put the Trij on a side flip mount? Speaking of the side flip mounts any/all of these can incorporate one if that makes a difference. I'm getting to where my mind is all cluttered up w/numbers, names, reticles, mounts et. al. and could use a fresh set of eyes (or a nap). Any advice is great, but constructive advice is appreciated. BC |
April 3, 2011, 06:59 PM | #2 |
Senior Member
Join Date: June 3, 2005
Posts: 381
|
Depends on your NVD. If it requires eye relief then yes, you will have trouble. Either ditch your magnifyer and go with NVD and then your eotech or procure a long eye relief magnified optic.
|
April 4, 2011, 11:32 PM | #3 |
Senior Member
Join Date: February 8, 2008
Location: Denver, CO
Posts: 1,925
|
You are going to have some serious issues fitting all 3 on. I'd suggest mounting your EOTech, and getting removable mounts for the magnifier and NV, and swapping them back and forth. It's going to be nearly impossible to have all 3 set up reliably.
|
April 5, 2011, 01:03 AM | #4 |
Senior Member
Join Date: November 17, 2008
Location: NW Ohio
Posts: 1,399
|
They do have night vision gear that mounts in FRONT of the optic. It would be possible to run all three, but man that would be a big, heavy setup!!
|
Tags |
optics |
|
|