September 28, 2002, 10:56 PM | #1 |
Senior Member
Join Date: October 12, 1999
Location: Snohomish, WA
Posts: 510
|
Recoil Pad profile?
I put a Boyds sporter stock on my GIBBS QE. Recoil hurts more than the original brass plate so I am looking into a recoil pad.
Are the shapes common among the butt plates? How do I get a recoil pad that will fit without dragging the rifle with me everywhere, never mind ordering over the internet.
__________________
http://www.geocities.com/gebooth2001 NRA, CCRKBA, GOA, WAC Sarin Nerve Gas:FOUND Ricin Toxin:FOUND Mustard Gas:FOUND Long Range Rockets:FOUND Nuclear material:FOUND 20 tons of Chemical weapons:FOUND Al-Queda FOUND |
September 29, 2002, 12:16 AM | #2 |
Member
Join Date: August 10, 2000
Posts: 64
|
You will have to have a smith grind and fit a recoil pad. They are not just bolt on. I guess you can get some bolt ons mow days, but if you want it to look good, haev a smith install one for you.
Pads run about $32.00 and instalation by a good smith is from $35.00 to $65.00 Celt |
|
|