December 20, 2006, 02:01 AM | #1 |
Junior Member
Join Date: December 20, 2006
Posts: 1
|
Question on 28ga AAHS
I'm new to this, but I want to start reloading shells for my 28 gauge O/U. I've been shooting factory AA HS shells. I'm finding very limited load data on the HS hull and what I have found is calling for AAHS wads.
My question is, should I stick with the AAHS or move to a different hull all together? I would prefer to cut my losses now if the AAHS isn't a good long term solution (limited load data, hard to find wads, etc). Also, any advice on good 28 ga field and target loads would be appreciated. Thanks in advance! Mossy |
December 20, 2006, 10:12 PM | #2 |
Member
Join Date: December 18, 2004
Location: Nevada
Posts: 93
|
The limited data is not related to the winchester hulls. It is limited to 28 guage. I would use the AA hulls, just order the wads you need online. I checked my Lyman manual and Federal, Remington,Winchester hulls all have about the same amount of load data choices for your 28. I use Winchester componets for our 12 guages and always have had good results. I usually order from midway.com. Hope this helps.
|
December 21, 2006, 10:00 AM | #3 |
Staff
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 41,389
|
I'm going to be hopefully finally buying a 28 in a couple of months, a CZ Ringneck SxS.
It will be a limited use fun gun, and I will probably stick with Winchester spec. loads and components for it.
__________________
"The gift which I am sending you is called a dog, and is in fact the most precious and valuable possession of mankind" -Theodorus Gaza Baby Jesus cries when the fat redneck doesn't have military-grade firepower. |
|
|