Iver Johnson small frame .32 short Hammerless:

James E · July 1, 2000, 09:41 PM

To Harvey Nolan, or anyone who may have a schematic parts drawing on Iver Johnson .32 short Hammerless 5-shot revolver. Need drawing so I can put this junker back together and sell it. I was give it in the pressent unworkable mode, Hammerless hammer won't cock...everything else seems OK...need parts drawing to see where everything goes, to try and put it back together.

Thanks for any help.

James

Harley Nolden · July 2, 2000, 07:04 AM

James:
I only had one small frame, .32 cal, blow up and have sent it by separate email. Hope this helps you.

HJN

July 1, 2000, 09:41 PM	#1
James E Junior member Join Date: April 20, 2000 Posts: 371	To Harvey Nolan, or anyone who may have a schematic parts drawing on Iver Johnson .32 short Hammerless 5-shot revolver. Need drawing so I can put this junker back together and sell it. I was give it in the pressent unworkable mode, Hammerless hammer won't cock...everything else seems OK...need parts drawing to see where everything goes, to try and put it back together. Thanks for any help. James

July 2, 2000, 07:04 AM	#2
Harley Nolden Staff In Memoriam Join Date: January 8, 1999 Location: Brunswick,GA USA Posts: 1,884	James: I only had one small frame, .32 cal, blow up and have sent it by separate email. Hope this helps you. HJN