|
June 9, 2000, 11:59 PM
|
#1 |
|
Senior Member
Join Date: February 8, 2000
Location: Tucson Arizona
Posts: 1,756
|
The fit between the trigger pin and the frame is starting to loosen up.I can see that the pin has moved a tad. How can I tighten the fit back up?(I had the pin out a couple of thousand rounds back when I took out the mag. safety)Thanks.
|
|
|
June 10, 2000, 07:31 AM
|
#2 |
|
Staff Alumnus
Join Date: October 12, 1998
Location: Earlington KY
Posts: 2,299
|
Railroader, take a cold chisel and hammer in 2 gooves about 1/8" long and 180 degrees apart on one end of the pin. This will expand that area and the pin should hold securely. George
|
|
|
 |
| Thread Tools | Search this Thread |
|
|
