The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old June 25, 2000, 12:32 PM   #1
Ron Ankeny
Senior Member
 
Join Date: April 3, 2000
Posts: 316
This has probably been asked and answered a million times and I kinda feel stoopid even bringing it up. Anyhow, I am shooting 200 grain LSWC bullets in my Baer .45 for IPSC and IDPA. The load barely makes minimum for IDPA with a power factor of 166 with 4.4 grains of WST at 830 fps. I have shot thousands of these loads.

Anyway, I came up with a couple of thousand 230 grain round nose lead bullets real cheap so I loaded them with 4.0 grains of WST for a velocity of 750 fps or a power factor of 172.

Common sense tells me the 230 grain bullets will kick more. More power, more pressure, so more recoil, right? Anyhow, I swear the 230 grain bullets have less muzzle flip. OK, so am I nuts or what? Maybe the recoil is just different and I can't put my finger on it. Which load should have the least muzzle flip? As you know, the straighter back a pistol recoils the faster you can shoot it (to a point). Thanks.

[This message has been edited by Ron Ankeny (edited June 25, 2000).]
Ron Ankeny is offline  
Old June 25, 2000, 09:19 PM   #2
Archie
Senior Member
 
Join Date: May 26, 2000
Location: Hastings, Nebrasksa - the Hear
Posts: 2,209
Normally, heavier bullets cause more muzzle flip; and will normally register higher on the target. Normally.

As you have found, it doesn't always happen. Since your velocity has lessened by a 100 f/s, your recoil profile has changed. If your 230 bullets were at the same velocity as the 200's, the recoil would unquestionably be greater.

Also, much of pistol shooting is subjective. A certain circumstance man not be true, but it sure seems that way. If the 230's group well, I wouldn't lose any sleep over it. But it is a nice puzzle.

------------------
Archie
Archie is offline  
Old June 26, 2000, 06:54 PM   #3
Bud Helms
Senior Member
 
Join Date: December 31, 1999
Location: Middle Georgia, USA
Posts: 13,198
It isn't just the bullet weight that gives recoil and muzzle flip, bullet velocity is part of the formula too.

If a 200 gr bullet at 830 fps gives a certain recoil (ft lbs), then a lighter bullet going faster or a heavier bullet going slower can be tweaked (velocity) to give the same recoil. Remember a reduction in powder of only .4 grs of the WST, from 4.4 grs in your example, to 4.0 grs, is 9.1%!

If you assume a 9.1% heavier bullet (218 gr) and a slightly higher muzzle velocity of, say 770 fps, with the same 4.0 grs of WST,
you get about the same recoil energy, for the same gun weight. That's a tribute to the consistency of the powder.

I calculated it from the formula in Lyman reloading book, No 47. Try it yourself.
Bud Helms is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:03 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.03305 seconds with 10 queries