Broomhandle extractor late model

dosta43 · March 13, 2009, 01:45 PM

I finally found one; now, how to install? Do I need a gunsmith, or can I do it myself?

Thanks

James K · March 13, 2009, 01:59 PM

The broomhandle extractor is its own spring. To remove, use a screwdriver to push up behind the front hook, while pulling forward out of engagement with the bolt. It is in this step that extractors are often broken which is why most folks will advise against removal unless necessary. If the hook is broken off, it may be necessary to lift the front end with a small screwdriver while pushing the back or the "wings" with another screwdriver or punch.

To install, bring the extractor back as far as possible and hook it under the lips in the bolt. Then hold the rear end down while lifting up on the front, and slip the extractor back into its slot.

Note, some of the extractors on the market are castings and may be more brittle than the originals, so extreme care is called for.

Jim

dosta43 · March 13, 2009, 08:51 PM

Thanks, Jim--I shall get me to a gunsmith asap.

March 13, 2009, 01:45 PM	#1
dosta43 Junior Member Join Date: March 13, 2009 Location: Charlottesville, VA Posts: 2	Broomhandle extractor late model I finally found one; now, how to install? Do I need a gunsmith, or can I do it myself? Thanks

March 13, 2009, 01:59 PM	#2
James K Member In Memoriam Join Date: March 17, 1999 Posts: 24,383	The broomhandle extractor is its own spring. To remove, use a screwdriver to push up behind the front hook, while pulling forward out of engagement with the bolt. It is in this step that extractors are often broken which is why most folks will advise against removal unless necessary. If the hook is broken off, it may be necessary to lift the front end with a small screwdriver while pushing the back or the "wings" with another screwdriver or punch. To install, bring the extractor back as far as possible and hook it under the lips in the bolt. Then hold the rear end down while lifting up on the front, and slip the extractor back into its slot. Note, some of the extractors on the market are castings and may be more brittle than the originals, so extreme care is called for. Jim

March 13, 2009, 08:51 PM	#3
dosta43 Junior Member Join Date: March 13, 2009 Location: Charlottesville, VA Posts: 2	Thanks, Jim--I shall get me to a gunsmith asap.