January 7, 2011, 11:50 AM | #1 |
Senior Member
Join Date: April 11, 2010
Location: Rensselaer Co NY
Posts: 221
|
Model 41
I have a S&W model 41 that after 1 or 2 somtimes 3 clips fired , the clip will just fall out then it won't stay in. I had a local smith look at it and he said he just cleaned it real good and should be ok ran 2 clips through it and the same problem again, any suggestion short of sending it to S&W
|
January 7, 2011, 03:01 PM | #2 |
Member In Memoriam
Join Date: March 17, 1999
Posts: 24,383
|
You might have to recut the mag catch, but first try increasing the spring tension. With the grips off and the magazine out, use a small punch to push in on the little retainer above the magazine catch button (left side). Turn the button itself clockwise a turn at a time until the magazine won't release. Then back it off until the magazine releases.
Jim |
January 10, 2011, 03:12 PM | #3 |
Senior Member
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
|
Are you using Model 41 specific mags, or the newer S&W generic .22 mags? IIRC, the newer mags have a longer mag release cut. My buddy's 622 mags work fine in my 41 but not vice versa.
|
January 12, 2011, 12:18 PM | #4 |
Senior Member
Join Date: April 11, 2010
Location: Rensselaer Co NY
Posts: 221
|
Thank you Jim I will try this. I'm using 41 specific mags
|
January 24, 2011, 10:48 AM | #5 |
Senior Member
Join Date: April 11, 2010
Location: Rensselaer Co NY
Posts: 221
|
Problem solved
Thanks Again |
|
|