|
February 17, 2005, 05:21 PM
|
#1 |
|
Junior Member
Join Date: February 17, 2005
Location: Southern Maine
Posts: 3
|
Ruger Takedown?
Hello, folks
I just got a Ruger Security six, .357, stainless. I have done a lot of rifle work but I am fairly new to revolvers. Anyone know where I can get detailed takedown instructions, schematics, etc. for the Security Six? Thanks Parson Gun Those who beat their swords into plowshares will be forced to plow for those who don't. |
|
|
February 17, 2005, 10:32 PM
|
#2 |
|
Member
Join Date: September 28, 2004
Posts: 29
|
Ruger has their manuals on the website, shows takedown as far as removing mainspring, hammer, trigger assembly, and cylinder. They also (i think so) have schematics in there that showed me everything i needed to see to work on mine. Good luck
|
|
|
|
February 18, 2005, 03:53 AM
|
#3 |
|
Senior Member
Join Date: July 19, 2004
Location: Ms
Posts: 1,160
|
e-Gunparts.com
Numrich should have a shcematic for the security six. As far as instructions goes, AGI has some good armorors tapes, they may have one for the security six. If not for it, for ruger revolvers.
|
|
|
|
February 18, 2005, 01:41 PM
|
#4 |
|
Junior Member
Join Date: February 17, 2005
Location: Southern Maine
Posts: 3
|
Ruger - Took down!
Thanks for the replies, that was very helpful. I am shooting that baby today!
__________________
Those who beat their swords into plowshares will be forced to plow for those who don't. |
|
|
 |
|
|
