|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
October 26, 2012, 10:57 PM | #1 |
Junior Member
Join Date: January 15, 2010
Posts: 3
|
Carbon fiber bushmaster ar-15
I was wondering if someone has taken parts off of a carbon fiber ar-15 and used them on a mil spec (aluminum) ar-15. In other words, will the uppers interchange with the lowers? Thanks
|
October 27, 2012, 09:59 AM | #2 |
Senior Member
Join Date: February 21, 2012
Location: Wisconsin
Posts: 763
|
The uppers and lowers WILL interchange yes. They WILL fire yes.
The thing is personally I don't much trust carbon fiber and/or polymer receivers for ARs yet. I had a pre-Bushmaster carbon AR rifle and the lower receiver broke at the rear where you screw in the stock. Had a crack half way through the receiver. That was only after 5,000 or so rounds. Would they work as say an average hunter's rifle? I believe so - just don't plan on putting a lot of rounds through it.
__________________
This is who we are, what we do. |
|
|