February 22, 2012, 09:35 AM | #1 |
Senior Member
Join Date: February 27, 2011
Location: Michigan
Posts: 257
|
load for 44 desert eagle
I loaded some ammo for my dads 44 desert eagle and it almost cycles it but still hangs up (wont close all the way). The load I use is 240 gr. with the max load of H110 in the hornady book (forget what it is at the moment and book is not avaliable) I was thinking about up loading it a bit to see if it helps. we were shooting it with a 14 inch barrel on. also the safety would click half way down on most shots but when we got some factory ammo it wouldn't do that anymore. kinda weird
|
February 22, 2012, 11:20 AM | #2 |
Senior Member
Join Date: July 28, 2007
Location: Ohio
Posts: 11,756
|
How old is the Desert Eagle and how many rounds through it? The dual-nested twin recoil springs do need replaced after so many rounds -- if your pistol is cycling but won't close all the way, I'd explore this idea.
Also, not that you are ignorant, but it always pays to mention since it wasn't brought up: No unjacketed lead bullets in a Desert Eagle EVER, as they will clog up the gas port and fixing this may be near impossible. I run a Desert Eagle with 240gr Nosler JHPs and a stiff load of 2400. This load is max in some sources, a bit over in other sources, but it runs well.
__________________
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss. |
February 22, 2012, 02:24 PM | #3 |
Senior Member
Join Date: May 29, 2002
Location: Illinois :(
Posts: 550
|
I have had similar frustrating experiences loading 44 mag for the Desert Eagle. General cycling problems, failure-to-extract, failure to go into battery, etc. .
I have loaded it for 50ae and haven't had these problems, so I've always suspected that my middle-of-the-range 44 mag loads aren't giving it enough power to properly move that gigantic slide and springs. |
February 22, 2012, 05:04 PM | #4 |
Senior Member
Join Date: May 22, 2005
Location: USA The Great State of California
Posts: 2,090
|
I reload for my Desert Eagle XIX in .44 magnum. I load:
200 grain GDHP with 27.5 grains W296 270 grain GDSP WITH 21.5 grains W296 300 grain Nosler with 14.8 grains Alliant 2400 240 grain Nosler JHP with 19.3 grains of Alliant 2400 I've not have any cycling problems with these. There is not much spread high to low for W296 and these are the high end. For the Alliant 2400 there is more spread and these are toward the low end. I've had no problems with either of these powders in cycling the DE. My pistol is only a couple years old, is the basic 6" barrel and has perhaps 1500 rounds through it in .44 magnum and .357 magnum. Sevens might have a good point. Good luck and keep us DE users posted on how it goes.
__________________
Hook686 When the number of people in institutions reaches 51%, we change sides. |
February 22, 2012, 07:57 PM | #5 |
Senior Member
Join Date: February 27, 2011
Location: Michigan
Posts: 257
|
Thanks, we were useing semi jacketed and full jacket bullets and it didnt seem to matter. I will have to try some of the loads mentioned and see if this helps. I know the gun is old but I am not sure how much my dad has shot it. replacing the springs may help but it runs fine on factory ammo so it may just be the reloads.
|
January 16, 2013, 01:50 PM | #6 |
Junior Member
Join Date: January 15, 2013
Posts: 4
|
Desert Eagle 44 Mag load data
I've been lurking for a while reading post on Desert Eagle 44mags and their loads. I recently purchased one for myself; "yes I know movie gun and so on I've seen the hate posts." It is a gun I have wanted for some time. I know this is an old post but feel it needs to be revived and updated.
I have been reloading off and on since My first Red hawk in 1984 and would like to get some good information on powder, primer, and loads for the D.E. Specifically, what is the cleanest burning powder and most recommended by forum users. |
January 16, 2013, 08:44 PM | #7 | |
Senior Member
Join Date: February 16, 2007
Location: Shoreview, MN
Posts: 104
|
Quote:
|
|
January 17, 2013, 12:13 PM | #8 |
Junior Member
Join Date: January 15, 2013
Posts: 4
|
VV N110
can you supply load data; primer,bullet, and grains that you have found best for your 44 DE?
|
February 19, 2013, 02:45 PM | #9 |
Junior Member
Join Date: December 25, 2006
Location: orange county CA
Posts: 3
|
I know this is an older post but I wanted to chime in. I used to have the same problem. I have a MK7 and it's about 20 years old. I bought it brand new. I shoot 240gr FP with 24G of H-110. Almost 1 or 2 out of every mag would not let the slide close all the way. I would just have to bump the slide and it would fire np. I bought a Lee factory crimp die and have never had the problem again. It's been about 500 rounds and not one jam. Might look into your crimp and see if that takes care of it. Good shooting.
|
February 19, 2013, 04:22 PM | #10 |
Member
Join Date: February 19, 2013
Posts: 49
|
I had to sign up just to respond to this thread.
I have found my 44 desert eagle to simply be the most reliable auto I own! its the one weapon that has never ever jammed once in all the many years ive owned it. Ive shot all kind of ammo through her, all handloads. right now my favorite load is 180g JHP over 25.5g 2400. This gun is my favorite pistol! |
Thread Tools | Search this Thread |
|
|