The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: The Revolver Forum

View Poll Results: S&W 617 vs Ruger SP101 vs Ruger Single Ten
617 32 62.75%
SP101 5 9.80%
Single Ten 5 9.80%
Other (please specify) 9 17.65%
Voters: 51. You may not vote on this poll

Reply
 
Thread Tools Search this Thread
Old November 3, 2012, 07:58 PM   #1
TennJed
Senior Member
 
Join Date: September 26, 2010
Posts: 1,536
S&W 617 vs Ruger SP101 vs Ruger Single Ten

I am wanting a higher end 22lr revolver for plinking. I am looking for accuracy above all else. I think I have narrowed it down to a S&W 617, Ruger SP101, or a Ruger Single Ten. Does anyone have any good or bad experiences with these? Other suggestions?
__________________
Find out just how tall I am
By jumping in the middle of a river
TennJed is offline  
Old November 4, 2012, 12:47 AM   #2
Pfletch83
Senior Member
 
Join Date: November 3, 2012
Posts: 147
My vote went for the 617...

Nothing bad to say about the revolver.

Accurate as can be,and cheap to feed.
Pfletch83 is offline  
Old November 4, 2012, 06:30 AM   #3
Hal
Senior Member
 
Join Date: October 9, 1998
Location: Ohio USA
Posts: 8,563
Accurate?

I voted "other".

S&W M17 or 18.

The two I have put the 617 I once had to shame.
However - in fairness to the 617 in general - mine was a lemon from the get go & even if it hadn't been, it wasn't at all what I expected it to be when I ordered it.
I thought about sending it back to S&W, but, decided I didn't want to keep it anyhow so why bother.
The only good thing I can say about it was that I got a lot for it on a trade in.
The 10 shot, round butt frame, full underlug 6" barrel and I just didn't get along.

Some time later, I lucked into a pair of older M17's. The seller was asking $395 ea for them - after some haggling.
I offered him $700 for the pair & he said "sold".

They shoot like a house afire, balance nearly exactly the same as my 6" M19 and have a rich "old" S&W blue.
Hal is offline  
Old November 4, 2012, 06:52 AM   #4
Kreyzhorse
Senior Member
 
Join Date: April 12, 2006
Location: NKY
Posts: 12,463
Hard to beat the 617 in my experience.
__________________
"He who laughs last, laughs dead." Homer Simpson
Kreyzhorse is offline  
Old November 4, 2012, 07:00 AM   #5
Zhillsauditor
Senior Member
 
Join Date: October 19, 2008
Posts: 635
Other: Model 17.

I have had a 6" 617 and hated the balance (I'll get a 4" one of these days). I have a Single Ten, and like it. I have shot a SP101 and its abysmal trigger prevents me from really assessing it's accuracy.
Zhillsauditor is offline  
Old November 4, 2012, 07:00 AM   #6
Sturm&Rugerfan
Senior Member
 
Join Date: March 16, 2005
Location: Presto PA
Posts: 148
ruger sindle six hunter conv

http://www.youtube.com/watch?v=PbZOugqx9C0

can fire 22lr and 22win mag, easy to scope. some youtube reviews


www.youtube.com/watch?v=PbZOugqx9C0
Sturm&Rugerfan is offline  
Old November 4, 2012, 07:12 AM   #7
P-990
Senior Member
 
Join Date: May 2, 2002
Location: Only1/2WayThere
Posts: 1,316
I had to vote other as well, though if pushed I could change to "617." In my mind there are the S&W K-frame .22s and then the others. Get ye to the local gun shop and prowl the used racks for a Model 18 and 17 S&W. The square-butt frame and lighter barrel balances better and looks sharper than the full-lug models to me.

My M-18:



I've owned and fired Ruger Single-Sixes and lets just say it never left the safe after the S&W came home. The difference is that obvious. I have no experience with the SP-101, but I highly doubt it could make me leave my S&Ws.
__________________
NRA Master, Highpower Rifle, Across-the-Course
NRA Expert, Highpower Rifle, Mid-Range Prone
P-990 is offline  
Old November 4, 2012, 09:19 AM   #8
Hal
Senior Member
 
Join Date: October 9, 1998
Location: Ohio USA
Posts: 8,563
Quote:
I had to vote other as well, though if pushed I could change to "617."
That's what I thought too...it cost me a couple hundred dollars to find out I was wrong....
Hal is offline  
Old November 4, 2012, 09:53 AM   #9
kraigwy
Senior Member
 
Join Date: June 16, 2008
Location: Wyoming
Posts: 11,061
I voted "617". I shoot a M-18 in rimfire revolver competition. People with the 617 always eat my lunch. Not saying its more accurate then the Model 18.

Its the loading, 10 shots vs. 6. Plus the speed loaders for the 617 work better the my speed loaders for the Model 18.

Not going to get rid of my M-18 by a long shot, but the 617 is on my "short-to buy list".
__________________
Kraig Stuart
CPT USAR Ret
USAMU Sniper School
Distinguished Rifle Badge 1071
kraigwy is offline  
Old November 4, 2012, 11:05 AM   #10
dgludwig
Senior Member
 
Join Date: February 12, 2005
Location: North central Ohio
Posts: 7,486
I voted for the Model 617 on this poll and with my hard-earned money. It's a very nice revolver.
__________________
ONLY AN ARMED PEOPLE CAN BE TRULY FREE ; ONLY AN UNARMED PEOPLE CAN EVER BE ENSLAVED
...Aristotle
NRA Benefactor Life Member
dgludwig is offline  
Old November 5, 2012, 03:47 PM   #11
Tom C.
Senior Member
 
Join Date: October 18, 2002
Location: Southern Maryland
Posts: 259
I voted for the 617, but my Model 17 is probably more accurate. IME, the stainless guns from S&W and Ruger require significant barrel break-in before they shoot well. Mine have been a little rough, but when they were broken in, they were very accurate.
__________________
Tom
Tom C. is offline  
Old November 5, 2012, 04:22 PM   #12
Crow Hunter
Senior Member
 
Join Date: January 27, 2012
Posts: 1,078
For purely accuracy, the 617 that I used to have was very nice. Even with cheap Remington Golden bullets it was wonderfully accurate.

For pure plinking fun, I like the Ruger Single Six that I have now. I haven't tried a single 10 but I figure they are just as fun, and since they aren't convertible models, maybe they would be more accurate than mine.

(My Single Six is still more than accurate enough for plinking fun though)
__________________
I am no longer participating in gun forums.

Good luck.
Crow Hunter is offline  
Old November 5, 2012, 05:50 PM   #13
MrBorland
Senior Member
 
Join Date: May 31, 2007
Location: NC
Posts: 2,614
Quote:
I am wanting a higher end 22lr revolver for plinking. I am looking for accuracy above all else.
Of those on your list, I vote for the 617. I've never benched mine, but the target below was shot with my factory-stock 4" 10-shot 617, unsupported, 25 yards, double action. Accuracy wise, it's the equal of my vintage 6" K-22 Masterpiece.




Quote:
Other suggestions?
Higher end and accurate? Freedom Arms.
MrBorland is offline  
Old November 5, 2012, 06:14 PM   #14
TennJed
Senior Member
 
Join Date: September 26, 2010
Posts: 1,536
Thanks guys

The Freedom Arms is a little too high end for me, but one day

Last edited by TennJed; November 5, 2012 at 07:26 PM.
TennJed is offline  
Old November 5, 2012, 07:28 PM   #15
absolute0
Senior Member
 
Join Date: August 4, 2005
Location: Zimmerman, MN
Posts: 242
A used model 17 is the way to go IMHO..best $400-$500 you'll ever spend if you enjoy shooting handguns.
__________________
"Ice to See You" -McBain
absolute0 is offline  
Old November 5, 2012, 07:30 PM   #16
Crow Hunter
Senior Member
 
Join Date: January 27, 2012
Posts: 1,078
The only thing that I didn't like about the 617 was the 10 round cylinder.

Dumb as it sounds, one of the things that I liked least about it was the shorter double action trigger pull compared to a standard 6 round cylinder.

It was a much more "abrupt" action.

A 6 round cylinder is much more "smooth".
__________________
I am no longer participating in gun forums.

Good luck.
Crow Hunter is offline  
Old November 5, 2012, 07:46 PM   #17
1 old 0311-1
Junior member
 
Join Date: November 5, 2012
Posts: 89


With the price of ammo the last few years I have become a bit of a .22 fan. I have NOT owned, but shot the Ruger. The best ever? 617, mine is a no dash.
I paid $850 for mine without the target grips, they were switched at some time but with box, papers, and cleaning kit. I felt lucky to find one and would get another if I ever find one.
They are more accurate than 99% of the population is, and shoots everything well. If you can afford the club, join.
1 old 0311-1 is offline  
Old November 5, 2012, 07:51 PM   #18
salvadore
Junior member
 
Join Date: January 1, 2007
Location: Idaho
Posts: 2,282
I have a 17 and a 617. The 17 is also my favorite, but only because I've owned it for a hundred years. The 617 was worth the price of admission, put 250 rounds thru it today abusing my portable gong thingy.
salvadore is offline  
Old November 8, 2012, 11:01 AM   #19
Jayhawkhuntclub
Senior Member
 
Join Date: December 13, 2007
Posts: 581
The single six is a must own relover, if there is such a thing. The single 10 is a head scratcher to me. Why try to squeeze in 4 more rounds into a single action of all things. You lose the ability to convert to 22mag. And SAs aren't meant to be high volume lead throwers. It also looks ugly. I guess I prefer a traditional 6 shot in a SA.

The sp101 would be a great option if the triggers weren't awful. Granted with a little work, the trigger can be improved all the way to mediocre.

The 617 is definitely the way to go. It will probably still need a trigger job and quality control at S&W is no better than any of the others. But once you get it up to snuff, it's awesome. Nothing wrong with 17s or 18s. But the stainless 617 is way more durable and you'll get a lifetime service agreement that won't come with a 17 or 18 (Or were some still made after 1989?).
Jayhawkhuntclub is offline  
Old November 11, 2012, 06:29 AM   #20
kcub
Senior Member
 
Join Date: October 24, 2010
Location: Austin, Texas
Posts: 3,318
I would recommend one of the older target topbreaks made by H&R. They are as accurate as anything and will simultaneously eject the 9 spent casings. Mine prefers standard velocity .22 ammo.

Smiths in particular get very sticky and hard to extract.
kcub is offline  
Old November 11, 2012, 07:19 AM   #21
Scrumbag
Senior Member
 
Join Date: May 22, 2012
Posts: 173
Other, I have a 6" M17. Cracking little firearm.

ATB,

Scrummy
Scrumbag is offline  
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.10546 seconds with 11 queries