The Firing Line Forums

Go Back   The Firing Line Forums > The Skunkworks > Handloading, Reloading, and Bullet Casting

Reply
 
Thread Tools Search this Thread
Old June 21, 2000, 08:21 PM   #1
johnwill
Senior Member
 
Join Date: April 6, 2000
Location: PA
Posts: 3,451
Has anyone come up with a better solution for adjusting dies than the silly sheet metal wrench that Dillon ships with their presses? I've asked a number of people, and so far I come up empty. It's a PITA to properly adjust dies with the tools I have, including that cheap Dillon sheet metal crap. I'd love to find a truly thinwall socket that would fit Dillon and RCBS dies, it would make the adjustment painless.
johnwill is offline  
Old June 22, 2000, 09:27 PM   #2
MADISON
Senior Member
 
Join Date: January 1, 2000
Location: Roanoke, Virginia
Posts: 2,678
RCBS and possibly LYMAN sells a wrench that fits "their" locking rings.
MADISON is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:32 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.04103 seconds with 10 queries