|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Search this Thread |
December 25, 2010, 10:12 PM | #1 |
Senior Member
Join Date: October 5, 2007
Posts: 397
|
SP101 trigger problem help
I have a SP101. The gun was functioning prior to tinkering (imagine that) I took it apart to install a Wolf spring kit. I got it all put back together and it and the trigger would not pull back. I took it apart and followed the reinstallation steps as well as I could understand. It will cycle a few times then it wont then it will. I reinstalled everything without the pawl installed and it pulls fine. I am wondering if there is something simple to watch for or change. I am installing the trigger group with the transfer bar and the pawl straight up. When it does cycle its mighty smooth. I will be grateful for any help.
|
December 25, 2010, 10:32 PM | #2 |
Staff
Join Date: February 12, 2001
Location: DFW Area
Posts: 24,971
|
If the trigger return spring from the spring kit you installed is too light it may not have enough oomph to fully reset the trigger each time. That will cause the trigger to appear to lock up.
__________________
Do you know about the TEXAS State Rifle Association?
|
December 25, 2010, 10:34 PM | #3 |
Senior Member
Join Date: October 5, 2007
Posts: 397
|
I think I have found I was missing the plunger and spring that hold the pawl.
|
Thread Tools | Search this Thread |
|
|